Simple Deluxe 100W/150W Reptile Heat Bulb And 8.5/10.5 Inch Clamp Light, 40-108 Degrees Fahrenheit Digital Thermostat Controller And Thermometer Included, For Amphibian Pet & Incubating Chicken

Ceramic Reptile Heat Bulb:Specifications:Socket: E26;Volt: AC 110-120V;Watts: 150W;Material: ceramic, NiCrAl;Diameter of heating surface: 85mm;Note: 1. Lamp surface temperature is too high, do not directly touch during it works; 2. Before remove it from fixture, please allow at least 1 hour for cool to avoid scald ; 3. Accidents may happen due to improper operation so please use it in a right way and avoid using in damp environment; 4. Please adjust the distance between the lamp and the pets, at least 35cm; 5. Please away from combustible or explosive materials;Clamp Light:Specification:Volt: 120V;Watt: Accepts up to 150W bulb (E26);Reflector Diameter: 8.5 inch;Cord: 6 feet;18/2 SPT-2 cord clamp light can also be used as a table lamp in your room, garages or art studios, a work light in photography and workshops, amphibians and reptiles pets terrarium heat lamp, and even a growth light for indoor plants.Warning: The power cord on this product contains chemicals, including lead known to the State of California to cause cancer. Wash hands after use.Digital Thermostat Controller:Specifications:Temperature control range: 40?-108°F;Temperature display range: 32?-140°F;Rated Voltage: AC 120V 60Hz ;Max Loading: 8A 1000W ;Easy plug-in operation with LED illuminated indicator lights & three-prong ground plug. Digital thermostat can also be used to control the temperature of many other appliances as long as they don't exceed the maximum electrical specifications stated above. Simply place the sensors in the area where the temperature needs to be controlled plug the appliance into thermostat, and set the desired temperature.Abnormal Warning: 1. If thermostat shows 'E1', it means that the actual temperature is lower than 0? or 32?; 2. If thermostat shows 'E2', it means that the actual temperature is higher than 60? or 108?. 3. If thermostat shows 'E3', it means that the temperature sensor is not working properly. Please re-install the sensor;